Setting tear off position on a 2480/2481 Lexmark Printer

Before starting you must verify that the Top of Form is set. If the top of form isn't setup correctly the tear off position can't be set.

1. Press Start/Stop to take the printer offline.
   • The ready light will goes out.
   • If the light doesn't go out it may be locked. Contact IBS for unlocking instructions.
2. Press and hold Tear Off until the printer beeps.
3. Open the operator panel cover.
4. Press Micro Up or Micro Down to move the paper to the correct position on the tear off bar.
5. Close the operator panel.
   • The printer beeps twice.
   • The paper will then roll backward, then go to the new Tear Off position.
6. The Ready light is On.
7. Press Start/Stop.

IBS Lumber and Building Material Software Copyright © 2006 IBS Lumber Software Inc (TM)
Last modified: November 7, 2011

IBS Sales & Support 888-640-1252
Main Office 888-640-1252
Fax IBS 877-712-8937

All pages contained in this support website are not intended for general public distribution. Any material here can be considered private, confidential with various copyrights and restrictions against public release. You 'the browser' cannot legally release this information for general public distribution.

remote support: http://www.gotomeeting.com | remote support download program