|
          
| |
Driver Downloads
- Windows 2000 Driver v5r05
released 02/27/2002
- Windows 98 Driver v3r46
released 03/26/2002
- Windows 95 Driver v3r46
released 03/26/2002
- Windows ME Driver v3r46
released 03/26/2002
- Windows XP Driver unknown
version & release date
[back to top]
Serial Number and Model Type Information
- To find your serial number and/or model type look about two inches below
the control panel. You may have to tilt the Printer back to see it.
- The serial number will read S/N 11-????
- The model number will read something like 248X-00?
- Several model types include:
2480-001, 2481-001, 2380-001, 2380-002, 2380-003, 2381-001, 2381-002,
2381-003
- 2480 and 2380 series printers are the high impact reports and ticket
printers
- 2481 and 2381 series printers are the high impact reports printers
[back to top]
How to Reset the Lexmark 24XX Printer to factory defaults
- Verify that the paper is loaded and the ready light is solid green
- Power off the printer.
- Remove the printer ribbon access cover.
- Push the printhead to the left manually until it reaches the carriage
rest.
- While holding down the Tear Off and Tractor
buttons, power the printer back on.
- The printer is now reset to factory default
[back to top]
How to Set the Forms thickness on a Lexmark 23XX and 24XX printer
- Locate the forms thickness lever on the
front left-hand side of the printer (blue on the 23xx, gray on the 24XX). The
lever is numbered 1 through 7. The lower the number, the tighter the paper
path; the higher the number, the wider the paper path. As a rule, the highest
setting (number) that is compatible with the print quality desired is best for
the printer.
- When setting the forms thickness lever, start by setting the lever to the
number of copies in your form (including carbons) plus 1. For example, set the
lever to 2 for a single-part form, for a
two-part form, set it to 3, and so on.
- Test the print quality and adjust as needed.
[back to top]
Common Questions
[back to top]
|
